Qwerkbot+ » 3. Qwerk Test

Required Tools

Image	Tool
	Flathead Screwdriver

Required Parts

Image	Part
	Zonet USB Wireless Adapter
	NiCd Battery (Charged)
	Power Connector from Step 1
	Two wired motors from Step 2

1. Before beginning, make sure the Qwerk board is switched OFF.


2. Connect the two motors by pushing the stripped end of the wires into the screw down terminal hole. Connect one motor to port '0' and the other to port '1'. Place each stripped wire in the appropriate port, and use a #4 flathead screwdriver to connect the screw terminal. Give the wire a sharp tug to ensure that is tightly connected to the screw terminal.


3. Place the USB wireless adapter in one of the two USB ports on the Qwerk.


4. Using the power connector made in step 1, connect a charged NiCD battery pack to the Qwerk and turn it on.


5. Go to the Qwerk First Steps guide and test the functionality of your Qwerk and the connected motors.


6. Turn off the Qwerk and disconnect motors, battery, and USB wireless adapter.

Return to Overview | Proceed to Step 4