Qwerkbot+ » 9. Qwerk Reassembly

Required Tools

Image	Tool
	Phillips Screwdriver

Required Parts

1. Holding the Qwerk board by the blue connectors, slide the Qwerk board back into the bottom half of the enclosure. The USB port should be on the side away from the wheels. Be sure that the lower circuit board fits into the enclosure tabs.


2. Place the top half of the enclosure on top of the board. Affix the two enclosure plates together with the four enclosure screws you removed in step 4.1. Remove the battery pack to access the front two screws, replacing it when the enclosure is reassembled.

Return to Overview | Proceed to Step 10